Differential Seals - RH: Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

If the vehicle is equipped with a PTU, use the special tools to install the RH differential seal.

Fig 1: Installing RH Differential Seal Using Special Tools (1 Of 2)

Courtesy of FORD MOTOR CO.

If the vehicle is not equipped with a PTU, use the special tools to install the RH differential seal.

Fig 2: Installing RH Differential Seal Using Special Tools (2 Of 2)

Courtesy of FORD MOTOR CO.

If equipped, install the PTU. For additional information, refer to TRANSFER CASE - POWER TRANSFER UNIT (PTU) article.
Install the RH halfshaft. For additional information, refer to FRONT DRIVE HALFSHAFTS article.
Using a small amount of thread sealant on the threads, install the transaxle drain plug.
- Tighten to 25 Nm (18 lb-ft).

Fig 3: Transaxle Drain Plug

Courtesy of FORD MOTOR CO.

Fill the transaxle with clean automatic transmission fluid.
Start the engine and run through all the gears and check the fluid level.