Intermediate and Overdrive Servo
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
The intermediate and overdrive servo is the hydraulic actuator which applies the intermediate and overdrive band assembly. Line pressure is applied through the servo apply circuit where it works on one side of the servo piston. This forces the piston to move up the servo bore in the transaxle case, which moves the servo apply rod against one end of the intermediate and overdrive band assembly. Because the other end of the intermediate and overdrive band assembly is anchored to the transaxle case, the ends of the intermediate and overdrive band assembly are squeezed around the reverse clutch drum assembly, holding the reverse clutch drum assembly stationary.