Symptom Chart - Brake System

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Condition	Possible Sources	Action
The red brake warning indicator and the yellow ABS warning indicator are illuminated	DTCs in the ABS module	REFER to VEHICLE DYNAMIC SYSTEMS article to diagnose the ABS module.
The red brake warning indicator is illuminated and the yellow ABS warning indicator is not illuminated	Brake fluid level and/or brake fluid leaks	INSPECT the system for leaks, REPAIR as necessary. FILL the brake master cylinder reservoir to the MAX line.
	Parking brake	MAKE SURE the parking brake is fully released. If it is fully released, go to Pinpoint Test C .
	Wiring, terminals and connectors Instrument cluster ABS module	RETRIEVE and RECORD any ABS module DTCs. If any ABS module DTCs are present, REFER to VEHICLE DYNAMIC SYSTEMS article. If no ABS module DTCs are present, RETRIEVE and RECORD any SJB DTCs. If any SJB DTCs are present, REFER to MULTIFUNCTION ELECTRONIC MODULES article. If no SJB DTCs are present, go to Pinpoint Test C .
The red brake warning indicator is inoperative	Wiring, terminals and connectors Instrument cluster	REFER to INSTRUMENT CLUSTER (IC), MESSAGE CENTER, AND WARNING CHIMES article to diagnose the instrument cluster.
The brakes pull or drift	Tires	INSPECT the tires for uneven or excessive wear, and correct inflation. REFER to WHEELS AND TIRES article to diagnose the tires.
	Brake pads	INSPECT the brake pads for contamination, uneven taper or excessive wear, REFER to Brake Pads .
	Brake discs	INSPECT the brake discs and the hubs for contamination or damage. INSTALL new brake discs or hubs as necessary. REFER to FRONT DISC BRAKE article for front disc brakes or REAR DISC BRAKE article for rear disc brakes. REFER to FRONT SUSPENSION article for front hubs or REAR SUSPENSION article for rear hubs.
	Brake calipers and/or guide pins	INSPECT the brake calipers and guide pins, REFER to Brake Calipers and Brake Caliper Guide Pins .
	Suspension component and/or wheel alignment	INSPECT the suspension and CHECK the wheel alignment. REFER to SUSPENSION SYSTEM - GENERAL INFORMATION article to diagnose the suspension system.
Brake pedal goes down fast	Brake fluid leaks and/or air in the system	INSPECT the system for leaks. REPAIR as necessary. FILL the brake master cylinder reservoir. BLEED the system. REFER to Brake System Bleeding - Hybrid .
	Brake master cylinder	CARRY OUT the Brake Master Cylinder Component Test in this article.
	Hydraulic control unit (HCU)	INSPECT the HCU. REFER to VEHICLE DYNAMIC SYSTEMS article to diagnose the HCU.
The brake pedal eases down slowly	Air in the system	BLEED the system. REFER to Brake System Bleeding - Hybrid .
	Brake master cylinder	CARRY OUT the Brake Master Cylinder Component Test in this article.
	HCU	INSPECT the HCU. REFER to VEHICLE DYNAMIC SYSTEMS article to diagnose the HCU.
Brakes lock up under light brake pedal force	Brake pads	INSPECT the brake pads for uneven taper or excessive wear, REFER to Brake Pads .
	Brake calipers and/or guide pins	INSPECT the brake calipers and guide pins, REFER to Brake Calipers and Brake Caliper Guide Pins .
	Parking brake shoes out of adjustment	REFER to PARKING BRAKE AND ACTUATION article for the parking brake shoe adjustment procedure.
	Anti-lock brake control system	CHECK the anti-lock brake control system. REFER to VEHICLE DYNAMIC SYSTEMS article to diagnose the ABS.
Excessive/erratic brake pedal travel	Brake fluid leaks and/or air in the system	INSPECT the system for leaks. REPAIR as necessary. FILL the brake master cylinder reservoir. BLEED the system. REFER to Brake System Bleeding - Hybrid .
	Brake calipers and/or guide pins	INSPECT the brake calipers and guide pins, REFER to Brake Calipers and Brake Caliper Guide Pins .
	Brake flexible hose	INSPECT the brake flexible hoses for swelling and damage. INSTALL new as necessary. REFER to FRONT DISC BRAKE article for front disc brakes and REAR DISC BRAKE article for rear disc brakes.
	Brake pads	INSPECT the brake pads for taper wear, REFER to Brake Pads .
	Brake pedal	INSPECT the brake pedal for binding, obstructions and correct installation. REPAIR as necessary. CHECK the brake pedal fasteners for correct torque. REFER to Specifications in HYDRAULIC BRAKE ACTUATION article.
	Anti-lock brake control system	CHECK the anti-lock brake control system. REFER to VEHICLE DYNAMIC SYSTEMS article.
Brakes drag	Parking brake component	REPAIR or INSTALL new components as necessary. REFER to PARKING BRAKE AND ACTUATION article.
	Parking brake shoes out of adjustment	REFER to PARKING BRAKE AND ACTUATION article for the Parking Brake Shoe Adjustment procedure.
	Brake caliper guide pins	INSPECT the caliper guide pins for correct operation. INSTALL new components as necessary. REFER to Brake Caliper Guide Pins .
	Brake caliper(s)	REPAIR or INSTALL new brake calipers as necessary. REFER to FRONT DISC BRAKE article for front disc brakes or REAR DISC BRAKE article for rear disc brakes.
	Brake master cylinder	CARRY OUT the Brake Master Cylinder Component Test in this article.
Excessive brake pedal effort	Brakes are in manual mode	CARRY OUT the ABS module self-test. RECORD the DTCs. REFER to ABS Module DTC Chart in VEHICLE DYNAMIC SYSTEMS article.