Tire Pressure Monitoring System (TPMS) Sensor: Disassembly
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
The tire pressure monitoring system (TPMS) sensor battery may release hazardous chemicals if exposed to extreme mechanical damage. If these chemicals contact the skin or eyes, flush immediately with water for a minimum of 15 minutes and get prompt medical attention. If any part of the battery is swallowed, contact a physician immediately. When disposing of TPMS sensors, follow the correct procedures for hazardous material disposal. Failure to follow these instructions may result in serious personal injury.
NOTE:
Tire pressure sensors are equipped with Lithium-ion batteries and must be disposed of accordingly.
NOTE:
Tire pressure sensors are manufactured in multiple colors based on their application. When installing a new sensor, make sure the color of the sensor being installed matches the color of the sensor that was removed. The different colored sensors are not
interchangeable.
NOTE:
The sensor can be removed and installed without removing the strap or the cradle.
- Remove the tire from the wheel. For additional information, refer to Wheel and Tire .
- Using a pocket screwdriver or similar tool, remove the sensor locking clip.
- Using a pocket screwdriver or similar tool, detach the sensor from the cradle.
- Remove the sensor.
NOTE:
The sensor, cradle and strap may be damaged by incorrect tire mounting or dismounting. Dismount the tire only as instructed.
NOTE:
Do not use a large screwdriver. Apply minimum force during removal or damage to the sensor locking clip may occur.
NOTE:
Do not use a large screwdriver. Apply minimum force during removal or damage to the sensor may occur.