LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2090 (Engine Controls - Powertrain DTC Charts And Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> P1000 - On-Board Diagnostic (OBD) Systems Readiness Test Not Complete

P1000 - On-Board Diagnostic (OBD) Systems Readiness Test Not Complete

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2008 Mercury Sable, 2008 Mercury Mountaineer, 2008 Mercury Milan, 2008 Mercury Mariner, and 2008 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P1000 - ON-BOARD DIAGNOSTIC (OBD) SYSTEMS READINESS TEST NOT COMPLETE

Description:  The OBD monitors are carried out during the OBD drive cycle. This DTC is stored in continuous memory if any of the OBD monitors do not carry out their full diagnostic check.
Possible Causes: 
  • The vehicle is new from the factory
  • Battery or powertrain control module (PCM) had recently been disconnected
  • An OBD monitor concern occurred before completion of an OBD drive cycle
  • PCM DTCs have recently been cleared with a scan tool
  • Power take off (PTO) circuit concern or PTO is on during testing.
Diagnostic Aids:  This DTC, inspection/maintenance (I/M) readiness function is part of the PCM strategy. A battery disconnection or clearing codes using a scan tool results in the various I/M readiness bits being set to a not-ready condition. As each non-continuous OBD monitor completes a full diagnostic check, the I/M readiness bit associated with that monitor is set to a ready condition. This may take 1 or 2 drive cycles based on whether concerns are detected or not. The readiness bits for comprehensive component monitoring (CCM), misfire and fuel system monitoring are considered complete once all the non-continuous monitors have been evaluated. Because the EVAP system monitor requires certain ambient conditions to run, special logic can bypass the monitor for the purpose of clearing the EVAP and I/M readiness bit, due to continued presence of these extreme conditions. DTC P1000 does not need to be cleared from the PCM except to pass an I/M test. The malfunction indicator lamp (MIL) flashes after a period of time with the key in the RUN position (engine not running) if DTC P1000 is set.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All   See Note 2 See Note 2 refer to PINPOINT TEST QC .
scientia non olet · About LEMON Manuals