LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2090 (Engine Controls - Powertrain DTC Charts And Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> P0602 - Powertrain Control Module (Pcm) Programming Error

P0602 - Powertrain Control Module (Pcm) Programming Error

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2008 Mercury Sable, 2008 Mercury Mountaineer, 2008 Mercury Milan, 2008 Mercury Mariner, and 2008 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P0602 - POWERTRAIN CONTROL MODULE (PCM) PROGRAMMING ERROR

Description:  This DTC indicates a programming error within the vehicle ID (VID) block.
Possible Causes: 
  • VID data corrupted by the scan tool during VID reprogramming
Diagnostic Aids:  Using the scan tool, reprogram the VID block. If the PCM does not allow reprogramming of the VID block, reflashing of the PCM is required.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All   The VID block must be programmed. Refer toFLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , Making Changes to the VID Block.
scientia non olet · About LEMON Manuals