Evaporative Emission (EVAP) Canister Purge Valve
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2008 Mercury Sable, 2008 Mercury Mountaineer, 2008 Mercury Milan, 2008 Mercury Mariner, and 2008 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The EVAP canister purge valve may also be referred to as a vapor management valve (VMV).
The EVAP canister purge valve is part of the enhanced EVAP system that is controlled by the PCM. This valve controls the flow of vapors (purging) from the EVAP canister to the intake manifold during various engine operating modes. The EVAP canister purge valve is a normally closed valve. The EVAP canister purge valve controls the flow of vapors by way of a solenoid, eliminating the need for an electronic vacuum regulator and vacuum diaphragm. The PCM outputs a signal between 0 mA and 1,000 mA to control the EVAP canister purge valve.
| Item | Part Number | Description |
|---|---|---|
| 1 | - | Fuel Vapor to Intake Manifold |
| 2 | - | Fuel Vapor to EVAP Canister |