LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2082 (Fuel Tank And Fuel Lines - (Hybrid)) >> Removal And Installation >> Fuel Tank Filler Pipe >> Installation

Fuel Tank Filler Pipe: Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the fuel tank filler pipe assembly in the vehicle.
    • Install the fuel filler pipe hose and clamp onto the fuel tank.
    • Tighten to 4 Nm (35 lb-in).
  2. Connect the fuel vapor vent hose to the evaporative emissions canister.
  3. Attach the fuel vapor vent hose retainer clips.
  4. Connect the fuel vapor tube quick connect coupling onto the fuel tank filler tube. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  5. Install the fuel filler pipe mounting screw.
    • Tighten to 10 Nm (89 lb-in).
  6. Using the special tool, install the fuel tank tube shield with new rivets.
  7. Install the 2 fuel filler pipe mounting screws.
    • Tighten to 3 Nm (27 lb-in).
  8. Install the fuel tank filler cap.
  9. Turn the ignition key to the ON position to pressurize the fuel system.
  10. Visually inspect the fuel system for leaks.
scientia non olet · About LEMON Manuals