LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2074 (Parking Brake System And Actuation) >> Removal And Installation >> Parking Brake Warning Indicator Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the parking brake control boot clips at the floor console by pressing inward on the base of the boot.
    2. Fig 1: Parking Brake Control Boot Clips
    GF0024651Courtesy of FORD MOTOR CO.
  2. Remove the warning indicator switch screw.
  3. Disconnect the warning indicator switch electrical connector.
  4. Remove the warning indicator switch.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals