Disassembly And Assembly
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | 2L126 | Bleeder screw cap |
| 2 | 2N033 | Bleeder screw |
| 3 | - | Dust boot (part of 2510 and kit 2128) (2 required) |
| 4 | - | Piston (part of 2510 and kit 2128) (2 required) |
| 5 | - | Piston seals (part of 2510 and kit 2128) (2 required) |
| 6 | - | Spring (part of 2510 and kit 2128) |
WARNING:
Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION:
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
- Remove the rear wheel cylinder. For additional information, refer to Wheel Cylinder .
- Remove the bleeder screw cap.
- Remove the bleeder screw.
- To install, tighten to 8 Nm (71 lb-in).
- Remove the 2 dust boots.
- Remove the 2 pistons.
- Remove the 2 piston seals.
- To install, lubricate the piston seals with clean brake fluid.
- Remove the spring.
- To assemble, reverse the disassembly procedure.
NOTE:
Inspect the wheel cylinder bore for excessive wear, corrosion or pitting. If any of these conditions exist, a new wheel cylinder must be installed.