LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Disc Brakes & Drum Brakes) >> Bleeding Brake System >> Bleeding Hydro-Boost Unit >> Except E550

Except E550

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, 2004 Ford Cutaway, and 2003 Ford RV Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fill power steering pump reservoir with MERCON® multipurpose automatic transmission fluid.
  2. Remove Powertrain Control Module (PCM) relay from battery junction box and crank engine for several seconds. See Fig 1.
  3. Check power steering oil reservoir, and add fluid if necessary. Install PCM fuse. Start engine. Turn wheels from lock-to-lock twice.
  4. Turn engine off. Depress brake pedal several times to discharge accumulator.
  5. Start engine, and turn wheels from lock-to-lock twice. If foaming occurs, stop engine, and allow foam to dissipate. Repeat lock-to-lock procedure until all air is removed from system.
Fig 1: Identifying PCM Relay
G00299488Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals