Drums Installed
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, 2004 Ford Cutaway, and 2003 Ford RV Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Raise vehicle, and support with safety stands. Remove adjusting hole cover rubber plug. Turn adjusting screw and expand brake shoes until drag is felt against brake drum.
- Loosen adjusting screw 10-12 notches. Drum should rotate freely without drag. If drum does not rotate freely, remove wheel and drum. Apply grease to brake shoe contact areas on backing plate.
- Reinstall wheel and drum. Install adjusting hole cover. Apply brakes. If brake pedal travels more than halfway to floor, clearance between brake shoes and drums is too great. Additional adjustment is required.