LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2064 (Automatic Transmission Cooler - (Hybrid)) >> General Procedures >> Motor Electronics Cooling System Draining and Filling >> Draining

Motor Electronics Cooling System Draining and Filling: Draining

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: The coolant must be recovered in a suitable, clean container for reuse. If the coolant is contaminated, it must be recycled or disposed of correctly.
CAUTION: Always refill the motor electronics cooling system (MECS) with the same type of coolant that was drained from the system. Do not mix coolant types.
  1. With the vehicle in DRIVE, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Turn the ignition to the OFF position.
  3. Remove the LH splash shield.
    4. Fig 1: Locating Retainers For LH Splash Shield
    G03901411Courtesy of FORD MOTOR CO.
  4. Place a suitable container below the transaxle.
  5. Loosen the hose clamps at the transaxle, then pull the hoses off to allow the coolant to drain.
    6. Fig 2: Hose Clamps At Transaxle
    GF0025244Courtesy of FORD MOTOR CO.
  6. Connect the hoses to the transaxle and install the hose clamps.
  7. Install the LH splash shield.
scientia non olet · About LEMON Manuals