LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2062 (Manual Transaxle/Transmission And Clutch - General Information) >> General Procedures >> Flywheel Runout Check

Flywheel Runout Check

WARNING: This page is about a different car, the 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools

Illustration Tool Name Tool Number
GF0000025
 Dial Indicator with Magnetic Base 100-D002 (D78P-4201-B) or equivalent
  1. Mount the special tool so that the indicator contact point rides on the straightedge which spans the clutch disc contact surface.
  2. Rotate the flywheel and check the runout. If the runout exceeds the maximum allowance, install a new flywheel.
    3. Fig 1: Checking Flywheel Runout (With Specifications)
    GF0025295Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals