Rear Brake Disc: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Ford Pickup Heritage, 2004 Ford Pickup, 2003 Lincoln Blackwood, 2003 Ford Pickup, and 2002 Lincoln Blackwood. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When removing the rear brake disc (2C026) in this procedure it is not necessary to disconnect the hydraulic lines.

Remove the rear disc brake caliper (2552). For additional information, refer to the appropriate Caliper in the service information.

NOTE: If the rear brake disc binds on the rear parking brake shoe and linings, remove the adjustment hole access plug and contract the parking brake shoe and lining.

Fig 1: Identifying Brake Disc

Courtesy of FORD MOTOR CO.

Remove the rear brake disc.

CAUTION: Use a hub-mount brake lathe if necessary to machine the rear brake disc.

Fig 2: Measuring Rear Disc

Courtesy of FORD MOTOR CO.

Measure the rear brake disc, and resurface if the disc surface has been scored. Install a new rear brake disc if below minimum thickness specification.