LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 206 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Front Brake Disc >> Removal (2WD)

Removal (2WD)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Ford Pickup Heritage, 2004 Ford Pickup, 2003 Lincoln Blackwood, 2003 Ford Pickup, and 2002 Lincoln Blackwood. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front disc brake caliper anchor plate. For additional information. Refer to in the appropriate Brake Caliper Anchor Plate service information.
  2. On 4x4 vehicles, remove the brake disc (1125).
  3. On 4x2 vehicles, remove the brake disc and hub (1102) as follows:
    1. Remove the hub grease cap (1131).
    2. Remove the cotter pin.
    3. Remove the nut retainer.
    4. Remove the spindle nut.
    5. Remove the front wheel outer bearing retainer washer (1195).
    6. Remove the outer front wheel bearing (1216).
    7. Remove the brake disc and hub.
    Fig 1: Identifying Removing Brake Disc and Hub
    G03884653Courtesy of FORD MOTOR CO.
  4. If necessary on 4x2 vehicles, remove the front wheel bearing.
    1. Remove the wheel hub grease seal (1190).
    2. Remove the front wheel bearing
    Fig 2: Identifying Removing Inner Front Wheel Bearing
    G03884654Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals