Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Do not remove the ignition lock cylinder and the ignition switch at the same time or damage to the column may result.

Remove the clockspring. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.
Disconnect the electrical connectors.

Fig 1: Multifunction Switch Electrical Connectors

Courtesy of FORD MOTOR CO.

Remove the 2 multi-function switch screws.
Remove the multi-function switch.
To install, reverse the removal procedure.