Selector Lever Knob: Removal

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Place the selector lever in the Overdrive (Circle D) position.

Fig 1: Locating Floor Shift Selector Lever In (D) Position

G03901632

Courtesy of FORD MOTOR CO.

Gently pry up to remove the upper selector lever trim ring.

Fig 2: Identifying Upper Shift Lever Trim Ring

G03901603

Courtesy of FORD MOTOR CO.

Remove the top finish panel.

Fig 3: Locating Top Finish Panel

G03901614

Courtesy of FORD MOTOR CO.

Remove the set screw.

Fig 4: Locating Shift Knob Set Screw

G03901624

Courtesy of FORD MOTOR CO.

Remove the knob and wiring by pulling straight up on the knob.

Fig 5: Shift Knob & Wiring

GF0025279

Courtesy of FORD MOTOR CO.

Remove and discard the shifter straw by pulling it straight up.

Fig 6: Shifter Straw

GF0025280

Courtesy of FORD MOTOR CO.