LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2053 (Automatic Transmission External Controls - Cd4E) >> Removal And Installation >> Selector Lever Bezel >> Installation

Selector Lever Bezel: Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the gearshift bezel.
    2. Fig 1: Gearshift Bezel
    GF0025283Courtesy of FORD MOTOR CO.
  2. Feed the overdrive cancel switch electrical connector wire harness into the opening in the bezel and install the knob.
    3. CAUTION: Do not overtighten the set screw or damage to the plastic straw will occur.
  3. Install the set screw.
    4. Fig 2: Locating Shift Knob Set Screw
    G03901624Courtesy of FORD MOTOR CO.
  4. Install the top finish panel.
    5. Fig 3: Locating Top Finish Panel
    G03901614Courtesy of FORD MOTOR CO.
  5. Install the upper shift lever trim ring.
    • To install the upper shift lever trim ring, orient the thick tab on the driver side front of the shifter and press into place.
    6. Fig 4: Identifying Upper Shift Lever Trim Ring
    G03901603Courtesy of FORD MOTOR CO.
  6. Move the shifter through all gears from PARK to DRIVE several times making sure that the shift knob set screw is not too tight.
scientia non olet · About LEMON Manuals