LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 204 (Supplemental Inflatable Restraint System) >> Disabling & Activating Air Bag System >> Disabling System >> Diagnostics Disabling Procedure (Driver & Passenger AIR Bags)

Diagnostics Disabling Procedure (Driver & Passenger AIR Bags)

WARNING: This page is about a different car, the 2003 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

This procedure should only be used when performing air bag system diagnostics.

  1. Record pre-set radio frequencies for reprogramming, if equipped. Disconnect negative battery cable. Wait at least one minute for back-up power supply to deplete stored energy.
  2. Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Connect Air Bag Simulator (418-F088/105-R0012) to clockspring connector at top of steering column (in place of air bag). See AIR BAG SIMULATOR  .
  3. Remove passenger-side air bag module. See PASSENGER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Connect air bag simulator to passenger-side air bag vehicle harness connector (in place of air bag). Connect negative battery cable.
scientia non olet · About LEMON Manuals