Transaxle Draining and Filling

WARNING: This page is about a different car, the 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Material

Item	Specification
SAE 75W-90 API-GL4 Gear Oil XY-75W90-QGL	WSS-M2C203-A1
Silicone Gasket and Sealant TA-30	WSE-M4G323-A4

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Remove the drain plug and drain the fluid.

Fig 1: Drain Plug

Courtesy of FORD MOTOR CO.

NOTE: Use a new gasket and apply sealant on the drain plug.

Install the drain plug.
- Tighten to 35 Nm (26 lb-ft).

Fig 2: Drain Plug

Courtesy of FORD MOTOR CO.

Remove the fill level inspection plug.

Fig 3: Fill Level Inspection Plug

Courtesy of FORD MOTOR CO.

Remove the transaxle fill plug.

Fig 4: Transaxle Fill Plug

Courtesy of FORD MOTOR CO.

Fill the transmission with gear oil until level with the fill level inspection plug hole.

NOTE: Use a new gasket and apply sealant on the fill plug.

Install the transaxle fill plug.
- Tighten to 35 Nm (26 lb-ft).

Fig 5: Transaxle Fill Plug

Courtesy of FORD MOTOR CO.

NOTE: Use a new gasket and apply sealant on the fill level inspection plug.

Install the fill level inspection plug.
- Tighten to 35 Nm (26 lb-ft).

Fig 6: Fill Level Inspection Plug

Courtesy of FORD MOTOR CO.