LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2032 (Manual Transmission) >> Disassembly And Assembly Of Subassemblies >> Differential - Front Wheel Drive (FWD) >> Disassembly

Differential - Front Wheel Drive (FWD): Disassembly

WARNING: This page is about a different car, the 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Backlash specification: 0.02-0.08 mm (0.0008-0.0031 in).
  1. Using the special tool, measure and record the backlash for the differential side gears. Install a new differential if beyond specification.
    2. Fig 1: Checking Backlash Of Differential Side Gears
    GF0025402Courtesy of FORD MOTOR CO.
  2. Remove the 10 bolts and the final drive gear.
  3. Using the special tools, remove the differential side bearing.
    • Discard the differential side bearing.
    4. Fig 2: Removing Differential Side Bearing
    GF0025403Courtesy of FORD MOTOR CO.
  4. Remove the spacer.
  5. Remove the vehicle speed sensor (VSS) drive gear.
  6. Using the special tools, remove the differential side bearing.
    • Discard the differential side bearing.
    7. Fig 3: Removing Differential Side Bearing
    GF0025403Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals