Power Steering Pump Pulley - 2.3L: Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the pulley is flush with the end of the power steering pump shaft.

Using the special tool, install the power steering pump pulley.

Fig 1: Installing Power Steering Pump Pulley

Courtesy of FORD MOTOR CO.

Position the A/C manifold tube assembly bracket and install the 2 nuts.
- Tighten to 8 Nm (71 lb-in).
Rotate the accessory drive belt tensioner clockwise and install the accessory drive belt.