Clutch Disc and Pressure Plate: Installation

WARNING: This page is about a different car, the 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Using the special tool, position the clutch disc on the flywheel.

Fig 1: Special Tool

Courtesy of FORD MOTOR CO.

Position the clutch pressure plate on the flywheel and install the clutch pressure plate bolts.
- Tighten to 29 Nm (21 lb-ft) in sequence.

Fig 2: Clutch Pressure Plate Bolt Torque Sequence

Courtesy of FORD MOTOR CO.

Install the transaxle. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION article.