LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 202 (Engine Controls - Removal & Installation - 7.3L 995 & 99F F450/550 Diesel) >> Air Induction Systems >> Air Cleaner >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, 2003 Ford Excursion, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. On vehicles with dual batteries, see DUAL BATTERIES  under MISCELLANEOUS. From the rear moving forward, release 4 retaining snaps and remove battery cover. Remove battery hold-down and battery.
  2. Disconnect filter minder electrical connector and air cleaner outlet tube.
  3. Remove battery tray/air cleaner assembly bolts and lift the rear of the battery tray/air cleaner assembly to disconnect Intake Air Temperature (IAT) sensor electrical connector. Remove battery tray/air cleaner assembly.
  4. To install, reverse removal procedure. Tighten battery tray/air cleaner assembly bolts to specification. See TORQUE SPECIFICATIONS . Ensure air cleaner inlet is correctly installed through and clear of the rubber air deflector. Ensure air cleaner inlet is correctly installed in the battery tray/air cleaner assembly and the battery cover retaining snaps are locked in place.
scientia non olet · About LEMON Manuals