LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2006 (Electronic Engine Controls - 2.3L - (Except Hybrid)) >> Removal And Installation >> Powertrain Control Module (PCM) >> Removal

Powertrain Control Module (PCM): Removal

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Any powertrain control module (PCM) replacement will require that ALL customer keys are available to be programmed at the time of installation. PCM replacement DOES NOT require new keys.
  1. Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION article.
  2. Remove the powertrain control module (PCM) stud bolt nut and position the wiring harness aside.
  3. Disconnect the 3 PCM electrical connectors.
  4. Remove the 2 stud bolts and the PCM.
  5. Remove the PCM cowl seal.
scientia non olet · About LEMON Manuals