LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1992 (Front Drive HALFSHAFTS) >> Removal And Installation >> Halfshaft >> Removal

Removal And Installation: Halfshaft: Removal

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove and discard the front wheel hub nut.
  3. Remove the ABS wheel speed sensor bolt and position the sensor aside.
  4. Remove the lower arm pinch bolt and nut from the lower arm.
  5. Separate the lower arm from the front wheel knuckle.
  6. Using the special tool, separate the front drive halfshaft from the front wheel hub.
    7. Fig 1: Separating Front Drive Halfshaft From Front Wheel Hub
    GF0024609Courtesy of FORD MOTOR CO.
  7. Using the special tools, remove the front drive halfshaft from the differential.
    8. Fig 2: Removing Front Drive Halfshaft From Differential
    GF0017354Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals