LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1991 (Engine - 2.3L - (Hybrid)) >> In-Vehicle Servicing >> Valve Cover >> Removal

Valve Cover: Removal

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the ignition coil-on-plugs. For additional information, refer to ENGINE IGNITION - 2.3L article.
  3. Disconnect the crankcase vent hose.
  4. Remove the 3 engine cover studs.
  5. Disconnect the camshaft position (CMP) sensor electrical connector.
  6. Disconnect the fuel rail pressure and temperature sensor electrical connector.
  7. Disconnect the cylinder head temperature (CHT) sensor electrical connector.
  8. Remove the 14 valve cover retainers, the valve cover and gasket.
scientia non olet · About LEMON Manuals