LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1990 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Lower Intake Manifold >> Removal

Lower Intake Manifold: Removal

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited, resulting in possible personal injury.
WARNING: Fuel in the fuel system remains under high pressure even when the engine is not running. Before repairing or disconnecting any of the fuel system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel, causing personal injury or a fire hazard.
  1. Release the fuel system pressure. For additional information refer to FUEL SYSTEM - GENERAL INFORMATION article.
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  3. Remove the upper intake manifold. For additional information, refer to Upper Intake Manifold .
  4. Disconnect the fuel supply tube quick connect coupling at the fuel rail. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  5. Disconnect the fuel rail pressure and temperature sensor electrical connector and vacuum tube.
  6. Disconnect the 6 fuel injector electrical connectors.
  7. Remove the 8 lower intake manifold bolts and the lower intake manifold.
    • Remove and discard the gaskets.
scientia non olet · About LEMON Manuals