LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1990 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Crankshaft Pulley >> Removal

Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE - 3.0L (4V) article.
  3. Use the special tool to hold the crankshaft pulley and remove the crankshaft pulley bolt.
    4. Fig 1: Locating Special Tool (303-D055) And Crankshaft Pulley Bolt
    GF0024221Courtesy of FORD MOTOR CO.
  4. Using the special tool, remove the crankshaft pulley.
    5. Fig 2: Removing Crankshaft Pulley Using Special Tool (303-009)
    GF0024222Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals