Pinpoint Test D: The Roof Opening Panel Is Noisy During Operation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

D1 CHECK THE ROOF OPENING PANEL GLASS FOR OBSTRUCTIONS OR DAMAGE
- Check the roof opening panel glass for any obstructions or damage from the following:
  - sand.
  - dirt.
  - leaves.
- Are there any obstructions or damage?
1. YES : REMOVE all obstructions. REPAIR the roof opening panel as necessary. TEST the system for normal operation.
2. NO : Go to D2.
D2 CHECK THE ROOF OPENING PANEL GLASS OPERATION
- Check the roof opening panel glass during operation.
- Is the roof opening panel glass loose or not correctly adjusted?
1. YES : ADJUST the roof opening panel. REFER to Roof Opening Panel Alignment . VERIFY all bolts are tightened to specification. TEST the system for normal operation.
2. NO : Go to D3.
D3 CHECK THE ROOF OPENING PANEL TRACKS
- Open the roof opening panel glass.
- Check the tracks for obstructions or signs of damage.
- Are the tracks OK?
1. YES : Go to D4.
2. NO : REMOVE all obstructions. REPAIR any damage as necessary. TEST the system for normal operation.
D4 CHECK THE ROOF OPENING PANEL SHIELD
- Check the roof opening panel shield for correct movement.
- Is the shield moving correctly?
1. YES : Go to D5.
2. NO : REPAIR or INSTALL a new roof opening panel shield. REFER to Roof Opening Panel Shield . TEST the system for normal operation.
D5 CHECK THE ROOF OPENING PANEL MOTOR
- Gain access to the roof opening panel motor.
- Open the roof opening panel.
- Does the motor make excessive noise?
1. YES : INSTALL a new roof opening panel motor. REFER to Roof Opening Panel Motor . TEST the system for normal operation.
2. NO : ADJUST the roof opening panel glass. REFER to Roof Opening Panel Alignment . TEST the system for normal operation.