P1145 (TCM) - Calculated Torque Error
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
P1145 (TCM) - CALCULATED TORQUE ERROR
| Description: | The transaxle control module (TCM) continuously monitors the controller area network (CAN) for calculated torque message from the powertrain control module (PCM). This DTC is set when the calculated torque is not within the expected range. | |||
| Possible Causes: |
|
|||
| Diagnostic Aids: | Monitor the TCM TQ_DSD PID. The PID value should be positive in DRIVE or LOW, negative in REVERSE, 0 Nm (0 lb ft) in PARK or NEUTRAL if the brake pedal is not applied. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory | |
| All | refer to PINPOINT TEST TU . | - | refer to PINPOINT TEST TU . | |