Limited Operating Strategy (LOS) Modes

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

For some hybrid electric system concerns the PCM may initiate one or more of the LOS modes. The objective of the LOS modes is to manage vehicle operation after one or more of the following systems are disabled due to a concern: engine, electronically controlled CVT, traction battery, or regenerative brake system. Some LOS modes limit the vehicle capability to a limp home condition. Other LOS modes fully disable the vehicle. The PCM initiates the appropriate LOS mode depending on the severity of the concern that was detected.

When the PCM detects system faults for which the LOS mode is initiated, it stores a corresponding diagnostic trouble code (DTC). The root cause of the concern that initiated the LOS mode may be in a different subsystem or component than indicated by the DTC. Therefore, these DTCs should be considered LOS or failure mode effects management (FMEM) only and are always assisted by the other, more detailed, circuit DTCs. The circuit DTCs should always be used to diagnose the problem before LOS or FMEM DTCs. LOS or FMEM DTCs do not mean that the subsystem or component they describe actually failed, but indicate the subsystem or component that is effected by the LOS mode.

P1A0C Hybrid Powertrain Control Module - Engine Disabled
P1A0D Hybrid Powertrain Control Module - Generator Disabled
P1A0E Hybrid Powertrain Control Module - Motor Disabled
P1A0F Hybrid Powertrain Control Module - Vehicle Disabled
P1A10 Hybrid Powertrain Control Module - Battery Disabled
P1A13 Hybrid Powertrain Control Module - Regenerative Braking Disabled
P1A14 Hybrid Powertrain Control Module - Transmission Disabled