LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 196 (Automatic Transmission Servicing) >> Removal & Installation >> Transmission Range Sensor >> Removal

Transmission Range Sensor: Removal

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2003 Lincoln Navigator, 2003 Lincoln Blackwood, 2003 Ford RV Cutaway, 2003 Ford Pickup, and 2003 Ford F550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place vehicle in Neutral. Disconnect negative battery cable. Raise and support vehicle.
  2. For RWD Navigator, remove dampener and bolts.
  3. Remove insulator-to-crossmember support nuts. Remove LH and RH heatshield-to-crossmember bolts.
  4. Attach a jack to transmission. Remove crossmember and bolts. Lower rear of transmission to gain access to sensors.
  5. Disconnect shift cable from manual control lever.
  6. Disconnect Transmission Range (TR), sensor harness connector. Remove manual control lever from shift cable. Remove 2 retaining bolts and TR sensor from case.
scientia non olet · About LEMON Manuals