LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1956 (Climate Control System - General Information And Diagnostics - F250-F550) >> General Procedures >> Heater Hose Coupling >> Connect

Heater Hose Coupling: Connect

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the tubes and lubricate with plain water.
    2. Fig 1: Coupling Retainer, Spacer, O-Ring Seals & Quick Disconnect Coupling Housing
    GF0007989Courtesy of FORD MOTOR CO.
  2. Install a new coupling retainer, spacer, and lubricated O-ring seals into the quick disconnect coupling housing.
    3. Fig 2: Installing Heater Hose
    GF0007990Courtesy of FORD MOTOR CO.
  3. Push the heater water hose with a quick disconnect coupling onto the tube.
  4. Make sure the coupling is fully engaged by lightly pulling on the heater water hose.
scientia non olet · About LEMON Manuals