LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1954 (Fuel System - General Information - F250-F550 Super Duty) >> General Procedures >> Fuel System Pressure Release - Diesel Engines

Fuel System Pressure Release - Diesel Engines

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in personal injury.
WARNING: Fuel in the fuel system remains under high pressure even when the engine is not running. Before servicing or disconnecting any of the fuel lines or fuel system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel, causing personal injury or a fire hazard.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect both battery ground cables. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  3. Open the fuel/water separator drain valve to release the fuel pressure.
  4. Fig 1: Opening Fuel/Water Separator Drain Valve
    GF0007646Courtesy of FORD MOTOR CO.