LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1951 (Full Frame And Body Mounting -- F250-F550 Super Duty) >> Removal And Installation >> Transmission Support Crossmember >> Removal

Transmission Support Crossmember: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the electrical connection from the transmission support crossmember.
    3. Fig 1: Disconnecting Electrical Connection From Transmission Support Crossmember
    GF0005501Courtesy of FORD MOTOR CO.
  3. Support the transmission.
  4. Remove the transmission insulator nuts.
    5. Fig 2: Locating Transmission Insulator Nuts
    GF0005502Courtesy of FORD MOTOR CO.
  5. Remove the nuts and bolts retaining the gusset to the frame.
    6. Fig 3: Locating Nuts And Bolts Retaining Gusset To Frame
    GF0005503Courtesy of FORD MOTOR CO.
  6. Remove the nuts and bolts retaining the gusset to the transmission support crossmember, then remove the gusset.
    7. Fig 4: Locating Nuts And Bolts Retaining Gusset To Transmission Support Crossmember
    GF0005504Courtesy of FORD MOTOR CO.
  7. Remove the transmission support crossmember nuts and bolts (RH side).
    8. Fig 5: Locating Transmission Support Crossmember Nuts And Bolts (RH side)
    GF0005505Courtesy of FORD MOTOR CO.
  8. Remove the transmission support crossmember nuts and bolts (LH side).
    • Position the lines to access the nuts and bolts.
    9. Fig 6: Locating Transmission Support Crossmember Nuts And Bolts (LH side)
    GF0005506Courtesy of FORD MOTOR CO.
  9. Remove the transmission support crossmember.
scientia non olet · About LEMON Manuals