Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.

Turn the ignition switch to the OFF position.
Disconnect the intake air temperature 2 (IAT2) electrical connector and wiring harness retainer.

Fig 1: Locating Intake Air Temperature 2 (IAT2) Electrical Connector

Courtesy of FORD MOTOR CO.

Remove the IAT2 sensor.
- To install, tighten to 18 Nm (13 lb-ft).

Fig 2: Locating IAT2 Sensor

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.