LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1940 (Supplemental Inflatable Restraint System - F250-F550) >> Removal And Installation >> Restraints Control Module (RCM) >> Removal

Restraints Control Module (RCM): Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
WARNING: The restraints control module (RCM) orientation is critical for correct air bag SRS operation. If a vehicle equipped with an SRS system has been involved in a collision in which the center tunnel area has been damaged, inspect the mounting and bracket for deformation. If damaged, the RCM must be replaced whether or not the air bags have deployed. In addition, make sure the area of the RCM is restored to its original condition.
WARNING: Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag SRS is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and properly position the sensor or any other damaged SRS components whether or not the air bag is deployed.
WARNING: To reduce the risk of personal injury, do not use any memory saver devices.
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage can result.
NOTE: The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a SRS fault.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
  1. Depower the system. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
    2. NOTE: The restraints control module (RCM) is mounted on the center tunnel under the instrument panel.
  2. Pull out to release the retaining clips and remove the RCM cover.
    3. Fig 1: RCM, Electrical Connector & Bolt
    GF0005460Courtesy of FORD MOTOR CO.
  3. Disconnect the RCM.
    • Disconnect the RCM electrical connector locking clip.
    • Disconnect the RCM electrical connector.
    • Remove the RCM retaining bolt.
  4. Remove the 2 remaining retaining bolts and the RCM module.
scientia non olet · About LEMON Manuals