Passenger Air Bag Module: Installation
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Position the passenger air bag module into the instrument panel (I/P). Install the passenger air bag module retaining nuts and bolts.
- To install, tighten to 9 Nm (80 lb-in).
- Install the passenger air bag module door.
- Align the passenger air bag module door and push in seating the 6 retaining clips.
- Connect the passenger air bag module electrical connector.
- Close the glove compartment.
- Repower the system. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
NOTE:
During air bag module installation, make sure all the deployment door clips are fully seated into the I/P.