LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1939 (Charging System (Battery, Mounting And Cables) - F250-F550) >> Removal And Installation >> Battery Cables - Diesel >> Removal And Installation >> Positive battery cable

Positive battery cable

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the starter solenoid terminal cover.
  2. Remove the nut and position the starter solenoid positive cable terminal aside.
    • To install, tighten to 12 Nm (9 lb-ft).
  3. Remove the nut and position the starter solenoid wire terminal aside.
    • To install, tighten to 5 Nm (44 lb-in).
  4. Remove the nut and position the generator B+ cable terminal aside.
    • To install, tighten to 8 Nm (71 lb-in).
  5. Disconnect the starter relay electrical connector.
  6. Remove the 9 pin-type retainers and the upper radiator air deflector.
  7. Remove the 4 bolts and position the 2 upper radiator support brackets aside.
    • To install, tighten to 12 Nm (9 lb-ft).
  8. Remove the nut and position the CJB cable terminal aside.
    • To install, tighten to 8 Nm (71 lb-in).
  9. Release the positive battery cable locators and remove the cable.
  10. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals