LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1938 (Information And Entertainment Systems (F250-F550)) >> Removal And Installation >> Antenna Lead-In Cable >> Removal

Antenna Lead-In Cable: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the antenna base. For additional information, refer to Antenna Base  in this article.
  2. Position the RH front fender splash shield away from the bulkhead.
    • Remove the 2 nuts.
    • Remove the screws.
    • Remove the pin-type retainers.
    • Position the RH front fender splash shield away from the bulkhead.
    Fig 1: Identifying RH Front Fender Splash Shield
    GF0008270Courtesy of FORD MOTOR CO.
  3. Remove the pin-type retainer and the lower RH A-pillar trim panel.
    Fig 2: Removing Pin-Type Retainer And Lower RH A-Pillar Trim Panel
    GF0008271Courtesy of FORD MOTOR CO.
  4. Separate the antenna lead-in cable grommet from the bulkhead and pull the excess cable into the passenger compartment.
    Fig 3: Identifying Antenna Cable Grommet
    GF0008272Courtesy of FORD MOTOR CO.
  5. Remove the audio unit. For additional information, refer to Audio Unit  in this article.
    6. NOTE: This vehicle uses an antenna lead-in cable that is attached to the instrument panel reinforcement and the defroster air duct. Do not remove the original antenna lead-in cable from the vehicle.
  6. Cut and remove the original antenna lead-in cable connectors and excess cable. Secure the remaining cable ends to avoid rattles or identification problems.
scientia non olet · About LEMON Manuals