LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1933 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat Track - Bucket and 40 Percent >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat. For additional information, refer to Seat - Front, Bucket and 40 Percent  in this article.
  2. Remove the safety belt buckle nut and disconnect the usage detection switch electrical connector, and remove safety belt buckle.
    • To install, tighten to 40 Nm (30 lb-ft).
  3. Remove the bolts.
    • To install, tighten to 25 Nm (18 lb-ft).
    Fig 1: Locating Bolts
    GF0005036Courtesy of FORD MOTOR CO.
  4. Disconnect the electrical connector.
    Fig 2: Locating Electrical Connector
    GF0005037Courtesy of FORD MOTOR CO.
  5. Remove the electrical harness pin-type retainer.
    Fig 3: Removing Electrical Harness Pin-Type Retainer
    GF0005038Courtesy of FORD MOTOR CO.
  6. Disconnect the seat motor electrical connector.
    Fig 4: Disconnecting Seat Motor Electrical Connector
    GF0005039Courtesy of FORD MOTOR CO.
  7. Remove the seat track.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals