LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1933 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat Cushion - Front, With Seat Integrated Restraints (SIR) >> Removal >> All seats

All seats

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the affected seat. For additional information, refer to Seat - Front, With Seat Integrated Restraints (SIR)  in this article.
  2. Remove the seat adjuster control knobs, covers and the seat side trim panel screws.
    • Remove the seat recliner lever cover screw and cover.
    • Pull to remove the lumbar control knob.
    • Remove the 3 seat side trim panel attachment screws.
    Fig 1: Locating Lumbar Control Knob, Seat Recliner Lever Cover Screw And Cover
    GF0004986Courtesy of FORD MOTOR CO.
  3. Remove the 2 screws securing the lumbar adjuster control to the seat track riser.
    • Push the lumbar adjuster control inward to provide clearance for the trim panel removal.
    Fig 2: Locating Lumbar Adjuster Control Screws
    G03925442Courtesy of FORD MOTOR CO.
  4. Pull the rearward lower corner of the side shield to disengage the metal retaining clip.
    5. CAUTION: Bend the side shield slightly to make sure the shield is not scratched by the recliner lever.
  5. Remove the side trim cover.


  1. Remove the 4 seat cushion pan attachment bolts. Lift off the seat cushion assembly.
    Fig 1: Removing Seat Cushion Pan Attachment Bolts
    GF0005050Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals