LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1933 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat - Front, With Seat Integrated Restraints (SIR) >> Installation

Seat - Front, With Seat Integrated Restraints (SIR): Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Make sure the bushing is press fit onto the fifth foot mounting hole.
  1. Position the seat in the vehicle. Install the retainers. Do not tighten at this time.
    2. WARNING: The seat anchor bolts and nut must be tightened in the specified order.
  2. Tighten the retainers in the following sequence:
    • Tighten the 2 new front bolts to 55 Nm (41 lb-ft).
    • Tighten the new rear bolt and then the nut (driver seat) or new rear bolt (passenger seat) to 55 Nm (41 lb-ft).
    • Tighten the new fifth foot bolt to 55 Nm (41 lb-ft).
  3. Install the fifth foot trim cover.
  4. Connect the usage detection switch and power seat electrical connectors located under the seat.
  5. Install the seat mounting retainer covers.
  6. Make sure the safety belt and buckle are accessible to the occupant after installation.
scientia non olet · About LEMON Manuals