LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1931 (Handles, Locks, Latches And Entry Systems (F250-F550)) >> Diagnostic Tests >> Locks, Latches and Entry Systems - Non Module Controlled >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect the following for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Binding latch mechanisms
    • Binding linkage
    • Misaligned door
    • Central junction box (CJB) fuse 102 (30A)
    • Circuitry
    • Door lock control switch
    • Door lock actuator
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. If the concern is not visually evident, verify the symptom. Go to Symptom Chart .