LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1931 (Handles, Locks, Latches And Entry Systems (F250-F550)) >> Diagnostic Tests >> Locks, Latches and Entry Systems - Module Controlled >> Principles of Operation >> Autolock Enable/Disable - Using the Keyless Entry Keypad

Autolock Enable/Disable - Using the Keyless Entry Keypad

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

A manual enable/disable mode allows the autolock feature to be turned off and on.

To enable or disable autolock using the keyless entry keypad:

  1. Enter the 5-digit permanent entry code into the keyless entry keypad.
  2. Within 5 seconds of entering the code, press and hold the 7/8 button on the keyless entry keypad.
  3. Within 5 seconds of Step 2, and while holding the 7/8 button, press the 3/4 button on the keyless entry keypad and release it.
  4. Within 5 seconds of Step 3, release the 7/8 button on the keyless entry keypad.

    5. If the autolock feature is disabled, the horn chirps once. If the autolock feature is enabled, the horn chirps once shortly and then sounds a second time for a longer duration.

scientia non olet · About LEMON Manuals