LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1925 (Fuel Charging And Controls - 6.8L (3V) - F250-F550) >> Removal And Installation >> Throttle Body - Spacer >> Installation

Throttle Body - Spacer: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position a new TB spacer gasket, the TB spacer and tighten the 4 lower bolts in 2 stages:
    • Stage 1: Tighten to 9 Nm (80 lb-in).
    • Stage 2: Tighten an additional 90 degrees.
  2. Install the 2 upper TB spacer bolts in 2 stages:
    • Stage 1: Tighten to 9 Nm (80 lb-in).
    • Stage 2: Tighten an additional 90 degrees.
  3. Install the PCV heated element and the 2 screws.
  4. Connect the brake booster vacuum hose.
  5. Connect the EVAP canister purge valve quick connect coupling to the TB spacer. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL article.
  6. Connect the PCV tube quick connect coupling to the TB spacer. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL article.
  7. Connect the main vacuum harness to the TB spacer.
  8. Install the TB. For additional information, refer to Throttle Body  in this article.
  9. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
scientia non olet · About LEMON Manuals