LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1924 (Fuel Charging And Controls - 5.4L (3V) - F250 & F350) >> Removal And Installation >> Throttle Body >> Installation

Throttle Body: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using a new O-ring seal, install the TB and tighten the 4 bolts in 2 stages.
    • Stage 1: Tighten to 9 N.m (80 lb-in).
    • Stage 2: Tighten an additional 90 degrees (1/4 turn).
  2. Connect the TP sensor electrical connector.
  3. Connect the electronic throttle control electrical connector.
  4. Install the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
  5. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
scientia non olet · About LEMON Manuals