Toe Adjustment - F-250 and F-350 Four Wheel Drive (4WD), F-450, F-550
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Using alignment equipment and the manufacturer's instructions, measure the toe settings.
- Refer to Alignment Specifications in the Specifications portion of this section for optimal alignment settings.
- If the toe settings are not within specification, go to the next step.
- Start the engine and center the steering wheel.
- Turn the engine off and, using a suitable steering wheel holding device, lock the steering wheel in the straight ahead position.
- Loosen the tie-rod adjuster sleeve nuts.
- Rotate the center link to the correct toe setting.
- Make sure that the RH tie-rod end is not misaligned, as shown in image 2. Adjust the position as necessary as shown in image 1.
- Tighten the tie-rod adjuster sleeve nuts to 55 Nm (41 lb-ft).
- Verify the toe settings and adjust as necessary.